Artikelnummer
712355

Brodit Aktive Halter Zebra TC215 zig.stecker - 3A boot

118,95 €
Auf Lager
-
+
  • Schneller Versand
  • Hochwertige Produkte
  • Sichere Zahlung
Details
Active holder with cig-plug

With tilt swivel. 3A charging. 12/24V. With Easy-switching system. Charging via pogo pins. Fits device with Zebra Original Rugged Boot.

The active holder charges your battery when it is in the holder. The charging device connects to the unit automatically when you put the unit in the holder. The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. Connects to the vehicle's cigarette lighter socket, 12/24 Volt.

 

Easy-switching system:

The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.

 

Weitere Informationen
Weitere Informationen
Zubehörmarke Brodit
Barcode 7320287123555
Empfohlener Verkaufspreis inkl. MwSt 118,95 €
Gerät mit oder ohne Hülle Mit Hülle
Haltereigenschaft Gerätespezifisch
Cable / Qi / charger type / connnector Molex, sig plug, piggy tail (Easy Switching)
Gerät laden über Pogo-Pins
Eingangsspannung 12/24V
Voltage (output) 5.4V
Max Amperage 3,0 Amp
Montage standaard AMPS
Halterschloss nein
Farbe schwarz
Produktinformation Brodit houder
Mehr anzeigen + Zeige weniger -
Rezensionen
Schreiben Sie eine Bewertung
Sie bewerten:Brodit Aktive Halter Zebra TC215 zig.stecker - 3A boot
Compatibility
Mehr anzeigen + Zeige weniger -
Instruction
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.
3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel and screw it into place. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.
4. The holder is in place.

Scroll to top